L!NGO branded ATA iAN-02EX Adapter Unlock Hack

L!NGO branded ATA iAN-02EX Adapter Unlock Hack

Unit: L!ngo: iAN-02EX
Firmware: 2.8.2.63b (some steps may be different for other revisions)

contact GRAPHiNEX.com Geeks for PAID SUPPORT. paypal $25/call, guaranteed to get your adapter unlocked. 9am-5pm EST. Ask for FRANK.

So, you had the l!ngo service, or obtained an old l!ngo adapter, and now you need to re-program it? Here are the instructions!

WARNING: This will erase the settings on your device. Don’t do this unless you mean to use it with a different voip provider than l!ngo!

LEGAL: Anyone worried about whether or not its legal to hack a device you own and no longer use, go see a shrink or find something else to spend your time worrying about. Do this proceedure at your own risk. We in no way claim responsibility.

To set up another voip provider, or even a SIP IP PBX, follow these instructions. I can’t take complete credit for this, but I must admit I
could not find it all in one place so here I have assembled and embelished it.

Set your computer’s local IP address to 172.25.25.2 (it must be on the subnet for the adapter config)

You need to HARD RESET this box while not connected on the internet via attached telephone to phone port 1

Double check: You are not connected to the internet right?

Your PC is connected to the LAN port.

Pick up an attached phone on line 1, dial *#456987#

If the code works the device will reboot automatically (Watch the lights and hear the clicking relays)

After that… you can log in as supervisor via a web browser pointed at http://172.25.25.1/

username: supervisor
password: GoHaWk3Y3$

$KunK$pit is the previous firmware password. L!ngo likes to change passwords during firmware updates.

Once logged in as supervisor you have to disable DOS denial of service and Zero out the Provisioning entries;
otherwise you will not be able to log in as supervisor once connected to the internet.

This device downloads configs from l!ngo (after hard reset) and locks itsself. You must avoid this automatic download,
and disabled it from happening in the future.

If you are unable to enter supervisor mode, the machine may have internet connection after hard reset code  *#456987#  and is
downloading config file and locking itsself from the internet. You must disconnect internet before performing hard reset!!!

Configure USER and SIP settings for your new VOIP provider.

contact GRAPHiNEX.com Geeks for PAID SUPPORT. paypal $25/call, guaranteed to get your adapter unlocked. 9am-5pm EST. Ask for FRANK.

other notes:

There are “feature codes” listed inside the L!ngo adapter’s interface that you might want to check out.

user mode access to the device (unnecessary)

username: user
password: ph3taswe

Conference and Transfer Calls Procedures (tested while connected via PiaF IP PBX and voicepulse)

Step 1 Perform a hookflash to place the current call on hold and obtain a second dial tone.

Step 2 At the dial tone, enter the telephone number or speed dial of the third party and wait for the call to ring.

Step 3 You have the following options:

•To transfer the call, hang up when the call rings or when the third party answers.

•To return to the original call, perform a hookflash before the call rings. If you perform a hookflash before the third party answers but after the call rings, you also return to the original call. If the transfer picks up and you perform a hook flash, you will conference call.

•If you hang up during a conference, you will terminate the call for all parties.

contact GRAPHiNEX.com Geeks for PAID SUPPORT. paypal $25/call, guaranteed to get your adapter unlocked. 9am-5pm EST. Ask for FRANK.